The plant density that maximizes corn grain and silage yield has been increasing through time.
The economic optimum plant density is a function of corn yield and quality responses, seed cost and grain or silage price. The economic plant density is lower than the plant density that maximizes yield.
UW researched optimum corn yield and economic plant density from 2000-2008. The target plant densities varied and ranged from 14,000 to 56,000 plants per acre. Adapted, high-performing hybrids were selected using results from the UW Corn Trials and varied for relative maturity (full-season and shorter-season). Milk per ton and milk per acre were estimated for corn silage using Milk2006.Maximum grain yield was measured at 38,000 plants per acre. Yield increased to this population and then decreased as plant density changed. In agronomic research, it is very difficult to measure grain yield differences less that 5 percent.
So, grain yields within 5 percent of the maximum grain yield were measured at plant density above 28 000 plants per acre.
Maximum forage yield was measured at 44,000 plants per acre and was within 5 percent of the maximum when plant densities were above 30,000 plants per acre. Forage quality as measured by milk per ton decreased linearly from a maximum at 20,000 plants per acre but was within 5 percent of the maximum across the range of plant densities measured.
Maximum Milk per Acre was measured at 41,000 plants per acre and was within 5 percent of the maximum at 28,000 plants per acre. These results are a good example of the trade-off that exists between forage yield and quality, i.e. the plant density that maximizes milk per acre is intermediate between plant densities that maximize forage yield and milk per ton.
Plant densities that maximize grain and forage yield are higher than currently recommended plant densities. These results indicate that the plant density that maximizes forage production is about 3,000 plants per acre higher than the plant density for maximizing grain yield. The economic optimum plant density is lower than the plant density required to maximize grain or forage yield. The economic optimum plant density is likely different between farms and fields within farms.
Adjusting plant density is probably one of the best ways to move off current yield levels.
Begin by planting a field to what you think is the optimum plant density and at two or three places in the field, increase your population by 10 percent. For example, if you currently plant at 30,000 plants per acre, do so for the majority of your field, but in two or three rounds increase the population to 33,000 plants per acre.
Measure yield at the end of the season and during the season watch for "runt" plants, tillering, prolific versus ear bareness on plants, big versus small ears, ear tip "nose-back" and plant lodging. Adjust the field accordingly the following year. To analyze seed costs use the Crop Seed Price Calculator to compare seed costs and planting populations. FG
—From Chippewa Valley Agricultural Extension Report
